"EZ" Motor Covers
Generous in size, each Motor Cover features a heavy duty draw rope to assure engine protection.

Tie Down Kit
Designed to complement the Greystone and Sundura lines by simplifying and reinforcing cover tie downs for trailering. Included in each Tie Down Kit are 25 Yards of high strength webbing, 10 buckles, and 1 reinforcement kit.

Support Poles
Made from non-corrosive aluminum with nonslip rubber tips on both ends or grommet tipped or snap tipped on one end. Convenient twist-lock feature allows adjustment from 36" to 64". (Snap-Tip poles come complete with Snap-Tip Support Pole Patch)

Airlette Cover Vent
Helps eliminate dampness, heat buildup, mildew, and odors. Easy to install and adjusts to canvas or plastic material up to 1/8" thick. Removable hood rotates 360 degrees. Made of non-corroding plastic. The opening is 3" in diameter, the hood is 2 3/4". The airlette measures 4 1/2" diameter overall. 2 per package.

Reinforcement Kit
Strengthen wear points and areas that come in contact with sharp edges with this kit. Revolutionary peel and stick adhesive-backed fabric patch bonds to the cover fabric creating strengthened areas. Included in each Reinforcement Kit are 4 peel and stick patches and 1 peel and stick patch with a snap for a mooring pole.

Super Support Bows
Designed to be used with either standard or nylon bow sockets or rail huggers.

Deluxe Rail Huggers
Designed to hold wood and aluminum Boat Cover Super Support Bows to side rails without scratching. Mounts permanently to ends of slat, are unbreakable, and will not rust. Comes complete with all mounting hardware. Packed one per package.

Bow Sockets
Secures Boat Cover Support Poles in position during storage. Standard Bow Sockets feature dual nickel-chrome plating. Nylon bow sockets are unbreakable nylon and feature extra deep sockets to fit most wood aluminum and fiberglass bows. Both standard and Nylon Sockets come complete with mounting screws. One per package.

Bimini Support Poles
Replaces rear straps for maximum support and stability. Allows bimini to be stored in "radar" position above the motor and fishing equipment which increases usable space. 48" in length. 2 poles per.

Deck Slides
Deck Slides allow you to adjust the position of the bimini top forward and aft. Made of aluminum and stainless steel hardware. 2 per kit.

SunShadow Bimini Gear Bag
This bag give you all the storage you need for sunglasses, wallets, maps, charts, cellular phones, and other accessories. When you are done boating for the day, just detach the bag from the bimini top and take it with you.

Inflatable Boat Bimini Mounting Hardware
Complete sets for mounting a bimini top to an inflatable boat. Two kits are available to accomodate inflatables with or without a lacing cuff.